4-Rail Fence
Four rails with tight spacing for a full, finished look along entries and frontage.
- Space between rails7¼″
- Ground to bottom rail1′ 0″
- Overall height57″
- Estimated price$26 / ft
Powder-coated steel that won’t rot, warp, or need repainting. Your crew spends its time on the property, not the fence line.
Labor is one of the biggest costs of keeping up a commercial property. A Kuptz Fence comes off the work order list.
The powder-coated finish won’t chip, peel, or crack. No staining, sealing, or repainting, ever.
Steel won’t rot, warp, or splinter, so there are no boards to swap out season after season.
No nails or screws to back out. Rails lock into the posts, so there’s nothing to tighten.
Wood, vinyl, and chain link wear out and get replaced. Kuptz is built to stay, so you budget for it once.
Wood, vinyl, and chain link keep costing you long after they go in. Kuptz doesn’t.
Corporate standards, HOA guidelines, or an architect’s spec. Pick the rail count and finish your site calls for. Every option uses the same posts, height, and finishes.
Four rails with tight spacing for a full, finished look along entries and frontage.
Three evenly spaced rails for a clean line around grounds, lots, and campuses.
A simple, open line for long perimeters and property lines, at our lowest price per foot.
*2-rail fences use our 4-rail gates. All prices are estimates. Your final price depends on your layout. See full pricing.
Anywhere a fence has to look professional and stay that way.
A clean, professional line along entries, frontage, and parking areas.
Long runs across open grounds that stay sharp without a paint crew.
Entrances, common areas, and trails, in the finish and rail count your guidelines call for.
Event venues, wineries, and boarding facilities that need to look good every day.
Entrances, frontage, parking areas, long perimeters, and sloped grounds. Kuptz goes wherever your site plan does.
Tee posts split one line into two, so long perimeters and cross fences tie together cleanly.
The same rail lock works in every post. No special-order parts, no layout headaches.
Rails angle up, down, left, or right by 22.5° where they meet the post. Berms, slopes, and curved drives are no problem.
4′ walk gates for foot traffic, and 10′ gates that pair up for a 20′ vehicle opening.
See Gate DimensionsStandard 8′ sections, 36″ post holes, and nothing to screw or nail. Your crew or contractor can put it up.
See How It InstallsMatching steel gates in both finishes. Go wide for vehicles and equipment, or keep it simple with a walk gate.
Room for maintenance trucks and equipment. Hang two from opposite end posts for a 20′ double-gate opening.
A walk gate for staff, visitors, and service paths.
Gates hang on end posts. 2-rail fences use our 4-rail gates. All prices are estimates. See full pricing
Texture black and gloss white are our only two colors, and either one fits most brand standards and design guidelines. The powder-coated finish won’t chip, peel, or crack, and it never needs paint.
Sharp, modern lines that pair with contemporary architecture and dark trim.
The classic white fence look, without the scraping and repainting.
Here are the ones property and facility managers ask us most. The fastest way to get answers for your site is to draw it.
Draw Your FenceIt comes down to the look your site calls for. 4-rail gives the fullest look, 3-rail is clean and balanced, and 2-rail is the most budget-friendly for long perimeters. All three use the same posts, height, and finishes.
Two: texture black and gloss white. Both are powder-coated and never need paint.
With three rail counts and two finishes, most guidelines are easy to meet. Check your requirements, then pick the combination that fits. Exact specs are on our dimensions page.
Almost none. No painting, staining, or sealing, and no boards to replace. An occasional rinse keeps it looking clean.
Wood, vinyl, and chain link need crews to paint, repair, and eventually replace them. Kuptz skips that work, so your maintenance team can spend its time elsewhere.
Yes. Our 10′ gates fit maintenance trucks and equipment, and two hung from opposite end posts make a 20′ double-gate opening. We also offer 4′ walk gates. See gate dimensions.
No. Kuptz is a rail fence built to define space and look sharp. It isn’t designed to keep people out or block the view.
Yes. Rails angle up, down, left, or right by 22.5° where they meet the post, so berms, slopes, and curved drives are no problem.
Fence runs $16 to $26 per foot depending on rail count, and gates run $600 to $1,000. Draw your fence to see an estimate for your site in minutes.
Yes. Kuptz goes up in standard 8′ sections with no fasteners, and the full installation manual walks your crew or contractor through every step. See how it installs.
Ready to plan your fence? Lay out your site and gates on a satellite view and see your estimated cost in minutes. Our team will follow up with recommendations for your property.